1 1/2" Locking Line Swivels 9000 lb.

Locking Line Swivels

These are typically constructed with a Bronze thrust bearing for tensile load and a radial bear-ing for bending load. They combine a high safe working load with a compact design. Due to the use of a Bronze bearing in place of a Roller bearing, rotation will only con-tinue up to a certain load, much less than the Safe Working Load. Once past this point, then rotation will only occur when pulling tension is relieved.Sizes 00505-020 and larger are supplied with a grease point for lubrication. This is particularly useful in overhead applications where high speed rotation is possible.All sizes of both types are pull tested to verify the 3:1 safety factor and all (swiveling) sizes are fully capable of rotation at full working load. Test certificates are available upon request.Sizes 00505-025 and larger are supplied with hexagon Clevis Pins. Smaller sizes have slotted Clevis Pins.For clevis detail and pin replacement see catalog sheet series 00000 (page 2). Under no circumstances should alternate Clevis Pins be used.Note: Line swivels are not designed to run around bull wheels and severe damage or injury may be incurred if this is done.